Psionic Audio - offering the Triad, the new Telos, the 3.14, and other high quality audio effects and custom audio solutions. Lyle Caldwell psionicaudio pisonic psyonic syonic sonic Triad 3.14 314 Z2 Lumos Fuzzy Logic fuzzylogic jmi vox ac30 ac30cc mod amp amplifier modification modifications mods mixers mixer electric guitar pedals pedal stomp box stompbox stompboxes effects effect distortion fuzz overdrive natural boost booster clean cleanboost remote volume control second master volume vintage big muff best korg sdd-3000 sdd3000 delay preamp preamplifier rack switch switcher switchers switching professional unbuffer unbuffers buffer buffers boutique

Telos Insert Loop

To allow you to control your signal path, we have put an Insert Loop between the buffer/boost stage of the Telos and the input of the Drive stage.

Connect any other effects you like between them using this insert loop.

Ground Jumper LocationThe Return jack sleeve connection is not connected to signal ground in normal operation. This prevents ground loops when using the second stage as a loop, and prevents the cable in the loop from acting as an antenna for RFI and noise.

However, you may find that you either lose signal completely or there is a lot of noise when you activate the loop. This will generally be an indication that you are using a bad cable, or one where the ground has been disconnected. Replace or repair the cable and retest.

In the very unlikely event you have noise or a loss of signal when using the loop, and you have tested the cables involved and found them to be working well, then turn the mini-slider switch on the bottom of the PCB (internally accessible) from LIFT to GND.